Model No.:WLD-CN
1. Connect AC adapter to AC outlet and to central unit. Power LED indicator will light up.
2. Remove insulation sheet at the back of the unit.
3. Sound one beep and Sensor LED will light from Sensor 1 to Sensor 5.
3-1. If any one of the sensor detected water leakage, the corresponding LED will flash until the no detection of leakage.
3-2. If there is no detection of water leakage, all the 5 LED’s will be off.
Then the unit will go into Ready to Detect mode.
4. Once the unit detected water leakage, unit will immediately sound warning tone and the corresponding LED will light up.
5. The LED will not be off until Reset button pressed.
6. If more than one Sensor detected water leakage, corresponding LED will also light up.
7. Check and see the Sensor area of leakage.
8. After all the leakage were repaired, press Reset button and resume to above number 3.
Use place:
1. Center air condition in the office or house.
2. Other big machine which should keep way of water.
3. Other customer needs.
Note :
1. Even if the AC power is OFF, the central unit will operate, detect water leakage and sound warning tone though the sound level is a little smaller than with AC power.
2. Central control unit is not waterproof. Therefore please do not place the unit where water may flow.
3. Do not place Sensor terminals on the metallic objects that may cause false warning sound.
Attention:
You must be a registered member of TradeXpro to reply to these Products or Trade Leads
Zoom Picture (Enlarge)
: